Trunks
304 Incoming Line Group
304 Incoming Line Group Assignment
Prerequisite Program:
This assignment is used to configure ILGs only, OLGs are configured in the Outgoing Line Group
Assignment 306. The same line can be placed in an ILG and OLG.
F
IELD
00 Group Number
01 Group Type
02 Trunk Type
03 Service Type
04 Private Service Type
05 GCO Key Number
06 Pooled Key Number
07 COS
08 DRL
09 FRL
10 QPL
11 DID Digits
12 Speech/3.1 KHz
13 Ringing Timer Delay 1
6-2
None
D
ESCRIPTION
Enter the group number of the line group that should be configured.
Possible values: 1~32 (CTX100), 1~50 (CTX670 Basic), 1~128 (CTX670 Exp),
(default = no value)
Select the ILG Type.
Possible values: Analog (default) or ISDN
Select the Trunk Type.
Possible values: CO (default) or Tie
Select CO Trunk Service Type.
Possible values: DID or DIT (default)
Select the Tie Trunk Service Type. This field is required when Trunk Type is set to
Tie.
Possible values: Standard (default) or QSIG
Select ILG GCO Key Group for DIT mode (see Trunk Type above). The same GCO
cannot belong to different ILGs.
Possible values: 0~32 (CTX100), 0~50 (CTX670 Basic), 0~128 (CTX670 Exp),
(default = 0)
Select ILG Pooled Line Key Group for DIT mode. The same Pooled Line Group
cannot belong to different ILGs.
Possible values: 0~32 (CTX100), 0~50 (CTX670 Basic), 0~128 (CTX670 Exp),
(default = 0)
Select Day 1, Day 2 and Night Values.
Possible values: 1~32 (default = 1)
Select Day 1, Day 2 and Night Values.
Possible values: 1~16 (default = 1)
Select Day 1, Day 2 and Night Values.
Possible values: 1~16 (default = 1)
Select Day 1, Day 2 and Night Values.
Possible values: 1~16 (default = 1)
Select number of DID digits received from CO.
Possible values: 0~7 (default = 0)
Select Bearer Capability 3.1 KHz Audio or Speech.
Possible values: Audio (default) or Speech
Select time to ring the Delay 1 destination.
Possible values: 1~60 sec. (default = 12)
Strata CTX Programming - Part 2: CTX WinAdmin Programming 11/03