X Strata Ctx Programming - Toshiba CTX100-S Programming Manual

Telephone Button Programming
300 Series Programs
Table 13-29 Programs 316~317 (continued)
Button Sequence
317-13 B Ch Selection
A7 " C‚yq
, n,
317-14 Initialize Type
A7 # C‚yq
, n,
317-15 Initialization Display
A7 $ C‚yq
, n,
317-16 SPID #1
A7 % C‚yq
, n,
317-17 SPID #2
A7 & C‚yq
, n,
317-18 T-Wait Timer
A7 ' C‚yq
, n,
317-19 Voice Calls
A7 ( C‚yq
, n,
317-20 Trunk Subscriber 1
A7! C‚yq
, n,
317-21 Trunk Subscriber 2
A7! C‚yq
, n, ,
Table 13-30 Bearer Capability Table
Circuit Mode
13-66
Value(s)
n = 1. Forward Cyclic
2. Backward Cyclic
(default)
3. Forward Terminal
4. Backward Terminal
n = 1. User Entry Of SPID
Auto SPID ON
2. User Entry Of SPID
Auto SPID OFF
3. Auto SPID
4. None (default)
n = Up to 4 digits
(default = User)
n = Up to 20 digits
n = Up to 20 digits
n = 1. Enable
2. Disable (default)
n = 1. One
2. Two (default)
n = Up to 10 digits
n = Up to 10 digits
C‚yq
Bearer Services
Speech
3.1 KHz
7 KHz
64 Kbps
Rate adaptation
from 56 Kbps
Unrestricted
Digital
Information
2x64 Kbps
Choose Idle B Channel selection method.
•
Select Forward Cyclic (from lowest number to highest number of
B-channel).
•
Select Backward Cyclic (from highest number to lowest number
of B-channel).
•
Select Forward Terminal for the lowest numbered B-channel.
Select Backward Terminal for the oldest number B-channel. (The
High-High B-channel selection)
Enter the Service Profile Identifier (SPID) type of initialization.
Enter the text to be displayed for SPID Initialization.
Enter the SPID value. These fields are required if you selected
National ISDN in Protocol. When no data is entered, any previously
entered information is overwritten.
Enable the T-Wait Timer. This field is needed if you selected National
ISDN in Protocol above. This timer, used along with the SPID,
assigns random initializing SPID times to prevent BRI interfaces from
re-initialize at the same time after a reset or power outage.
Select the number of simultaneous voice (speech) calls that can exist
at the same time on this interface.
Enter the telephone number for subscriber 1. Telephone number
should be consistent with D channel data. If no data is entered in this
field any previously programmed information is lost.
Enter the telephone number for subscriber number 2. If no data is
entered in this field any previously programmed information is lost.
Bellcore
National ISDN
X
X
X
X
Strata CTX Programming - Part 3: Telephone Button Programming 11/03
Summary
ETSI TTC
X X
X X
X X
X X
X X