Emergency Ringdown Assignment - Toshiba CTX100-S Programming Manual

Station
Assignment
F
IELD
06 Second Interdigit
Timer
07 Ring Xfer No
Answer Timer

Emergency Ringdown Assignment

Program Number(s): 216
Prerequisite Program:
Assigns Emergency Ring Down parameters to Primary DNs.
1. Complete the
Record Sheets"
page D-18.
2. From the Program Menu
click Station > Assignment.
3. Click on the RingDown tab
(shown right).
4. Enter a DN number in the
Primary DN field.
...or select an existing record
by clicking one of the
following buttons:
• List – view a summary
list of programmed
DKTs.
• Extended List – view a detailed list of programmed DKTs.
• Copy – Enter a DN in the Primary DN field and click Copy. Enter a new DN to assign existing
Station Timer settings.
5. Select the desired values. See descriptions below.
6. Click Submit
F
IELD
01 Emergency Ringdown
02 Emergency Ringdown
Timer
03 Destination
5-22
D
ESCRIPTION
Select the amount of time the system waits between dialed digits before terminating a
call (ROT is heard).
Possible values: 1~180 (default = 5)
Select the Ring Transfer Idle station or Busy station (Camp-on) Recall Time (in seconds)
Possible values: 1~600 (default = 32)
200 page 5-1
"Station Data
on
D
ESCRIPTION
Enable an Emergency Ringdown Number.
Possible values: Enable or Disable (default)
Enter the length of off-hook time that will cause a DN to originate an Emergency
Possible values: 0~60 (default = 0)
Enter the destination DN for the Emergency Ringdown.
Possible values: Up to 5 digits (default = no value)
Strata CTX Programming - Part 2: CTX WinAdmin Programming 11/03