Connecting Rbsu To Network Side (Te-Mode) - Toshiba STRATA CTX100 Installation And Maintenance Manual

ISDN Interfaces
RBSU/RBSS Interface Units
Strata CTX BRI Circuit EMC Ferrite Core Requirement
To ensure that the Strata CTX BRI circuit meets the EMC requirements, it is necessary to run all
wire connecting ISDN BRI circuits (TE, LT mode and NT mode) through a Ferrite core. Use
Toshiba part number, FER-CORE-ISDN, to order the ferrite core. It is not shipped automatically
with the BRI circuit cards, it must be grounded separately.
wiring through the Ferrite core.
Figure 5-14 BRI Circuit Ferrite Core Installation

Connecting RBSU to Network Side (TE-Mode)

The RBSU only, not the RBSS, circuits can be connected to the network side of a BRI line. The
RBSU circuits must be configured in the TE-mode (refer to option switches in
5-14 and
In the U.S., the BRI line from the ISDN service provider is a two-wire U-type BRI line. This line
connects to the RBSU TE circuit via a customer-provided NT1 as shown in
is necessary to convert the network BRI, two-wire, U interface to the RBSU BRI, four-wire, T
interface. The NT1 must be UL listed (U.S.) or CSA certified (Canada).
The NT1 is powered by local AC power via an AC adapter supplied with the NT1. The connection
between the NT1 and the RBSU TE circuit is a point-to-point connection, so the NT1 can connect
to only one RBSU BRI TE circuit.
A 100-ohm Terminating Resistor (TR) is required on each end of the point-to-point connection.
The TR must be switched into the RBSU TE circuit (refer to option switches in
5-19 and
5-20
RBSU or RBUU
ISDN
PRI Jack
4697
Ferrite Core
FER-CORE-ISDN
Note: Locate the Ferrite core
as close as possible to
the BRI modular jack.
Table 5-6 on page 5-18).
Table 5-4 on page 5-14) and into the NT1 device.
Figure 5-14
RBSS or RBUS
CAT 3, 4,
or 5 Cable
Tie
Wrap
One Turn
shows how to dress the
Table 5-4 on page
Figure 5-15. The NT1
Table 5-7 on page
Strata CTX I&M 10/02