Step 3B: Set Up Ip Address Of Ctx Winadmin Pc Modem (Windows Xp) - Toshiba CTX100-S Programming Manual

Step 3B: Set up IP Address of CTX WinAdmin PC Modem
(Windows XP)
This setup is only for direct connection to the Strata CTX or for simple Hub or LAN connections.
Note
For more complex LAN, WAN or Internet connections, refer to
Internet Connections"
1. Set up PC modem settings for CTX WinAdmin. Click Start > Control Panel > Network and Internet
Connection > Network Connections > Create a New Connection (under Network Tasks).
2. At the New Connection screen, click Next. Select radio button "Connect to the network at my
workplace" and click Next.
3. Select radio button "Dial-up Connection" and click Next.
4. Enter the company name as "Remote CTX1",
then click Next.
5. Leave the Phone Number to Dial field blank.
Click Next.
6. Click Finish.
7. At the Connect Remote CTX1 screen, click
Properties.
8. At the RemoteCTX1 Properties screen, select
the PC modem that should be used to connect
to the CTX modem.
9. Click the Networking tab.
10. Select Internet Protocol (TCP/IP).
11. Click Properties.
12. Select Use the following IP Address.
13. Enter an IP Address
same as the CTX IP address in Program 916 for CTX NIC Connections
your PC when using the modem connection. Click OK.
14. At the CTX1 Properties screen, click the Options
tab and set up options to the recommended settings
shown as shown right.
15. Click OK. You can go back and change these
settings later if needed.
16. At the CTX1 Properties screen, click OK and exit.
17. Go to "Step 1: Install CTX WinAdmin Software"
on page 3-14.
Strata CTX Programming - Part 2: CTX WinAdmin Programming 11/03
on page 3-5.
can be 1~252. It cannot be 253 or above. It cannot be the
192.168.255.x (where x
Step 3: Set up Modem Connection (Optional)
"Wide Area Networks and/or
. This is the static IP Address of
)
Installation
3-11