Toshiba CTX100-S Programming Manual page 79

F
IELD
09 Dial Input Timer
10 Delay 1 Ringing Timer
11 Delay 2 Ringing Timer
12 Door Unlock Timer
13 9+11 Judgement Timer
14 Emergency Call Timer
15 ABR Busy Detection
Time
16 Lost Call Timer
17 Lost Call Final Timer
18 DTMF Tone Sending
Time
19 Auto Disconnect
23 System Timer Network
DSS Refresh Timer
24 Outgoing Number
Display Timer
Strata CTX Programming - Part 2: CTX WinAdmin Programming 11/03
D
ESCRIPTION
Permits dialed input for a telephone and trunk using DTMF.
Possible values: 0~60 sec. (default = 20)
Specifies the time to wait before applying ringing to the designated phones.
Possible values: 1~60 sec. (default = 12)
Selects the time to wait before applying ringing to the designated phones.
Possible values: 1~60 sec. (default = 24)
Select the length of time to send an electrical signal to a door for releasing the lock.
Possible values: 1~30 sec. (default = 6)
The 9+11 Inter-digital timer provides a timing value (1~30 seconds) for the system to
wait for additional digits to be dialed looking for the 911 or 9+911 dialed codes for
treatment using the E911 procedures rather than normal dialing treatment.
Possible values: 1~30 sec. (default = 5)
Sets a time for advancing the call to the next station in a list of destinations for the
call.
Possible values: 10~180 sec. (default = 30)
The Destination Busy Detection timer sets the time to wait while looking for a busy
condition on an external call. If detected, it will trigger the initiation of the Automatic
Busy Redial cycle.
Possible values: 1~30 sec. (default = 5)
The Lost Call timer sets the time that a failed transfer recall will ring on the
originating station prior to attempting to recall a secondary location.
Possible values: 1~600 sec. (default = 180)
The Lost Call Final timer sets the time that a failed transfer recall will ring on the
secondary location before being automatically disconnected.
Possible values: 1~600 sec. (default = 30)
The DTMF tone sending duration for dialing on CO Lines.
Possible values: 80msec (default) or 160msec
Time after which an unsupervised trunk may be automatically released.
Possible values: 0~60 min. (default = 0)
Select Network DSS Refresh Timer (20 -180 seconds). The time interval when all
Network DSS settings are refreshed system wide.
Note DSS button LEDs change state immediately when the status of the DSS
button changes - regardless of this timer value.
Possible values: 20~180 seconds (default = 30)
This timer sets how long dialed numbers will display on telephone LCDs for outgoing
line calls. (This feature is available with CTX R2.2 or higher and CTX WinAdmin
R2.2G.0 and higher.)
Possible values:1~120 seconds (default = 10)
System
104 System Timer
4-11