Paging Devices Group Assignments - Toshiba CTX100-S Programming Manual

503 Paging Devices Group Assignments

Prerequisite Program:
Assigns BIOU Page Zone Relays to Page Groups.
1. Complete the
Assignment Record Sheet"
2. From the Program Menu, click Services >
External Device > Paging Devices.
3. Enter 00 Zone Relay Number.
4. Check the Paging Groups that you wish to
activate.
5. Select the external generic relay number.
6. Click Submit.
F
IELD
00 Zone Relay Number
01 PG 1~16 PG 16
17 All Page Group
18 All Emergency Page
Group
19 BGM Mute Relay
Strata CTX Programming - Part 2: CTX WinAdmin Programming 11/03
502 page 5-28
"Paging Device Group
on page D-54.
D
ESCRIPTION
Select the BIOU Page Zone relay that should be assigned to the Page Groups
below. This relay activates whenever the selected Page Group is paged.
•
BIOU1 = Zone Relays 1~4.
• BIOU2 = Zone Relays 5~8.
Possible values: 1~8 (default = no value)
Check the box if the selected BIOU Page Zone Relay should activate with this
Page Group.
Possible values: On or Off (default)
Assign BIOU generic relay as the BGM mute relay. This relay activates
whenever the external page is in use
•
BIOU1 = Generic Relays 1~4.
• BIOU2 = Generic Relays 5~8.
Possible values: 1~8 (default = 0)
Note The CTX100 ACTU built-in relay is programmed as relay 5. For this
relay operation,BIOU2 is installed, as default, in a virtual equipment
position - Cabinet 2, Slot 5, PCB code 20, in Program 100. To install
an actual BIOU2 and disable the ACTU built-in relay, use the
programming telephone to remove the virtual BIOU2 and then install
the actual BIOU2 in Cabinet 01 Slot 01~08 in the normal manner.
Services
External Devices
9-73