Strata Net Over Ip Programming Guidelines - Toshiba CTX100-S Programming Manual

Strata Net over IP Programming Guidelines

Use the following steps/programs to program Strata Net over IP.
1. Assign the BIPU-Q card using Program 100 (System > Card Assignments).
2. Use Program 151 to set up the BIPU IP address, subnet mask, and default gateway (IP Telephone >
BIPU Configuration).
3. Program ILG and OLG using Programs 304 and 306 (Trunk > ILG, OLG).
4. Program the Channel group using Program 302 [Trunk > ISDN > PRI (IP Protocol)].
5. After assigning an IP channel group in Program 302, assign the PAD levels to the PAD Groups 1 or 2 in
Program 107 (System > PAD Table) using the
6. After assigning the PAD level to the PAD Table in Program 107, assign the IP channel group to the PAD
group in Program 108 (System > PAD Table). Use ISDN trunk as the device type for IP Channel Group
Assignments.
These PAD values in steps 5 and 6 must be set properly to avoid low volume levels.
Important!
7. Assign network IDs for all nodes using Program 102 (System > Flexible Access Codes).
8. Program networking using Programs 651~656 (Services > Networking > Route Plan Analysis).
9. Setup Strata Net over IP routing using Programs 671 and 672 (Services > Networking > Network Over
IP). See example below.
10.If voice quality is low on Strata Net over IP calls, change defaults in Program 152 for parameters
FB01~FB04.
11. Use Program 320 (Trunk > ISDN > B Channel) to control the number of channels to be used. This may
be necessary to limit the number of simultaneous calls allowed over the IP network. The IP network
bandwidth determines how many simultaneous calls can be supported. As a general guideline one
Strata Net over IP call requires a minimum of 36 kbps bandwidth.
The BIPU IP address must be set in Program 151. If the BIPU-Q1A has a private IP address,
Important!
IP QSIG communication must be over a Virtual Private Network (VPN) connection. To avoid
needing VPN for this IP connection, assign a Global IP address to the BIPU-Q1A interface.
Example
Node 11
BIPU-Q1A
192.168.11.100
This BIPU IP
address * must be
set in PRG151.
CTX system
Figure 2 Strata Net over IP Routing
Strata CTX Programming - Part 4: Appendices 11/03
Router IP-Network
LAN
Router
BIPU-Q1A
192.168.13.102
This BIPU IP
*
address must be
set in PRG151.
Node 13
CTX system
Strata Net over IP Programming Guidelines
"PAD Table" on page 4-23.
Router
LAN
*
See Important note above.
Applications, Tips and Tricks
Node 12
BIPU-Q1A
192.168.12.101
This BIPU IP
LAN
address * must be
set in PRG151.
6833
CTX system
A-13