What To Do - Sun Microsystems Sun Enterprise 220R Owner's Manual

What to Do

1. Extend the server from the rack, and then position one person on each side of the
system, facing the system glides.
When you are both in position, verify that your helper understands what to do with
the system after you release the server and remove it. Also agree on a route to
follow, and visually inspect it for potential safety hazards (for example, cables on the
floor, other people working in the vicinity, and so on).
2. Locate the flat spring catch shown in the following figure.
Each person should visually locate one of the two flat spring catches that release the
system from the rack glide. One catch is attached to each inner glide, as shown in the
following figure:
Chapter 2 System Setup 21