Snmp Traps; Create Trap Host Table Entry; Figure 97. Trap Management Page - Allied Telesis AT-GS950/24 User Manual

SNMP Traps

Create Trap Host
Table Entry
A Host IP address is used to specify a management device that needs to
receive SNMP traps sent by the switch. This IP address is associated with
the SNMP Version and a valid Community Name in the Host table of the
switch.
Use the following procedure to create a trap Host table entry:.
1. From the main menu on the left side of the page, select the SNMP
folder.
The SNMP folder expands.
2. From the SNMP folder, select Trap Management.
The Trap Management Page is displayed. See Figure 97.

Figure 97. Trap Management Page

3. Enter the Host IP Address for the management device that is to
receive the SNMP traps.
The IP address must be in the xxx.xxx.xxx.xxx format.
4. Enter the SNMP Version (v1 or v2c) that is configured for the host
management device.
5. Enter a Community Name that you have previously defined in the
SNMP Community table.
Note
The Community Name must correlate with one of the communities
displayed on the SNMP Community Table page - see "SNMPv1/v2
Community Strings" on page 271. If you enter a Community Name
that has not been pre-defined, the Trap Host entry will be displayed,
but agent/manager communication will fail.
AT-GS950/24 Web Interface User Guide
273