Measuring/Adjusting Toe-In - Arctic Cat 400 Service Manual

15. Remove the ATV from the support stand.
Measuring/Adjusting
1. Thoroughly wash the ATV to remove excess
weight (mud, etc.).
2. Refer to the specifications and ensure the tires
are properly inflated to the recommended pres-
sure.
NOTE: Ensure the inflation pressure is correct in
the tires or inaccurate measurements can occur.
3. Place the ATV in a level position taking care not
to push down or lift up on the front end; then
turn the handlebar to the straight ahead position.
NOTE: When measuring and adjusting, there
should be a normal operating load on the ATV
(without an operator but with Arctic Cat approved
accessories).
4. Measure the distance from the outside edge of
each handlebar grip to the seat catch brackets.
Back
8-10
Toe-In
Back to TOC
5. Adjust the handlebar direction until the two
CD006
measurements are equal; then secure the handle-
bar to the rear rack using tie-down straps.
NOTE: Care must be taken not to allow the han-
dlebar to turn while securing it.
6. Measure the distance from the inside of each
front rim to the lower frame tube.
CD005
Back to Section TOC
CD012A
CD014
AF785D
Next