Arctic Cat 400 Service Manual page 283

10. Slide the reverse driven gear bushing onto the
shaft making sure the oil port in the bushing
aligns with the oil port on the shaft.
! CAUTION
Failure to align the oil ports will result in serious
engine damage.
11. Move the washer in the shaft groove until the
notches in the washer align with the tabs on the
bushing; then slide the bushing up tight against
the washer.
12. In order, install the reverse driven gear, washer,
circlip, and reverse dog onto the driveshaft.
Back
CC842
CC843
CC225D
Back to TOC
NOTE: The driveshaft is now completely assem-
bled for installation.
COUNTERSHAFT
Disassembling
1. Remove the 2nd drive gear and washer from the
countershaft.
Back to Section TOC
CC226D
3
CC227D
CC228D
Next
3-239