Arctic Cat 400 Service Manual page 337

DRIVEN PULLEY ASSEMBLY
Disassembling
! WARNING
This procedure involves relaxing a compressed
spring assembly. DO NOT attempt disassembling
without the proper tools.
1. Secure Driven Pulley Compressor (p/n 0444-121)
in a suitable holding fixture such as a bench vise.
2. Place the driven pulley assembly onto the com-
pressor tool base.
3. Tighten the nut against Spring Holder (p/n
0444-162) (C) to compress the springs; then
using a circlip pliers (B), remove the circlip
(A).
Back
KX588A
KX571
Back to TOC
4. Relax the spring by removing the nut and spring
holder; then remove the spring seats (A), spring
(B), and thrust plate (C).
5. Make matching marks (A) and (B) on the movable
sheave (C) and stationary sheave (D) to allow
installation in the same position.
6. Wipe out excessive grease; then using a standard
tip screwdriver (B), dislodge the four guide pins
(A).
Back to Section TOC
KX573A
3
KX281
KX282
Next
3-293