Arctic Cat 400 Service Manual page 349

2. Apply blue Loctite #242 to the thread area (C),
except tip (D) of left case cap screw (3); then
install and tighten the 8 mm cap screws to 2.0
kg-m (14.5 ft-lb) following the tightening
sequence 1-8. Tighten the 6 mm crankcase cap
screws (A) and (B) to 1.0 kg-m (7 ft-lb).
3. Install the breather tube (A) on the crankcase fit-
ting aligning the white line on the tube with the
mark (B) on the crankcase; then install the
clamp (C) directing the open end toward the left
side (D) of the crankcase.
Back
ATV2083
ATV2084A
ATV2085
Back to TOC
4. Apply grease to the steel ball (A) and spring (B);
then install the steel ball, spring, washer (C),
and shift shaft positioning bolt (D). Tighten the
shift shaft positioning bolt to specifications.
5. Check that the crankshaft and driven shaft turn
freely. If any of the shafts don't turn freely, sepa-
rate the crankcase halves to locate the problem.
6. Using the bearing driver (A), drive the bearing
into the housing until it bottoms out.
7. Place the bearing housing into the holding fix-
ture; then apply blue Loctite #242 on the threads
of the bearing retainer (A). Install with the
dished side (B) directed away from the bearing
and tighten to specifications.
Back to Section TOC
ATV2086
3
ATV2087
KX322
Next
3-305