Arctic Cat 400 Service Manual page 61

10. Remove the cylinder head from the cylinder,
remove the gasket, and account for two alignment
pins.
AT THIS POINT
To service valves and cylinder head, see
Servicing Top-Side Components sub-section.
11. Remove the cam chain guide.
AT THIS POINT
To inspect cam chain guide, see Servicing
Top-Side Components sub-section.
Back
MD1167
MD1163
MD1173
Back to TOC
C. Cylinder
D. Piston
NOTE: Steps 1-11 in the preceding sub-section
must precede this procedure.
12. Remove the two nuts securing the right side of the
cylinder to the right-side crankcase half. Account
for the washers.
13. Lift the cylinder off the crankcase taking care not
to allow the piston to drop against the crankcase.
Account for the gasket and two alignment pins.
AT THIS POINT
To service cylinder, see Servicing Top-Side
Components sub-section.
! CAUTION
When removing the cylinder, be sure to support the
piston to prevent damage to the crankcase and pis-
ton.
14. Using an awl, remove one piston-pin circlip. Take
care not to drop it into the crankcase.
Back to Section TOC
3
MD1226A
MD1214
Next
3-17