Arctic Cat 400 Service Manual page 358

8. Install the one-way clutch so the flange (A) fits on
the recess (B) of the race; then install on the
rotor/flywheel and attach with the cap screws.
Coat threads with blue Loctite #242 and tighten to
specifications.
9. Install the starter clutch gear (C) and torque limiter
(A); then wipe the crankshaft and rotor/flywheel
mating surfaces
rotor/flywheel (B) while turning the starter clutch
gear.
10. Ensure that the alignment pins (A) are installed;
then install the bearing (B).
Back
3-314
KX354
KX355
clean and install the
KX356
Back to TOC
11. Apply grease to the alternator cover oil seal; then
install the cover (B), cover cap screws (A), and
clamps (C). Tighten
specifications.
12. Install a new O-ring (A) in the collar (B); then
apply grease to the O-ring and install the collar
into the alternator cover.
13. Align the holes in the starter cup (A) with the pins
(B) in the collar; then hold the drive clutch with
the holder and tighten the rotor/flywheel cap screw
(C) to specifications.
Back to Section TOC
KX357
the cap screws to
KX358
ATV2096
Next