Center Crankcase Components; Separating Crankcase Halves - Arctic Cat 400 Service Manual

AT THIS POINT
To service center crankcase components only,
proceed to Separating Crankcase Halves.
Center Crankcase
Components
NOTE: This procedure cannot be done with the
engine/transmission
Removing procedures for Top-Side, Left-Side, and
Right-Side must precede this procedure.
NOTE: For efficiency, it is preferable to remove
and disassemble only those components which
need to be addressed and to service only those
components. The technician should use discretion
and sound judgment.
Separating Crankcase
1. Remove the five right-side 6 mm cap screws
(one from inside the case) securing the crank-
case halves. Note the location of the differ-
ent-lengthed cap screws.
Back
3-210
in the frame. Complete
Halves
Back to TOC
CC163D
2. Remove the seven left-side 6 mm cap screws
securing the crankcase halves. Note the location
of the wiring form. Note the location of the dif-
ferent-lengthed cap screws.
3. Remove the three left-side 8 mm cap screws
(two from inside the case) securing the crank-
case halves. Note the location of the differ-
ent-lengthed cap screws.
4. Remove the three right-side 8 mm cap screws
securing the crankcase halves.
Back to Section TOC
CC530D
CC096D
CC097D
Next