Auxiliary Brake Assembly Schematic; Throttle Control - Arctic Cat 400 Service Manual

Auxiliary Brake
Assembly Schematic
KEY
1. Brake Lever
2. O-Ring
3. Washer
4. Cap Screw
5. Spring
6. Clevis Pin
7. Washer
8. Cotter Pin
9. Brake Assy
10. Master Cylinder
11. Hose
12. Reservoir
13. Flange Nut
14. Machine Screw
15. Cable Tie
16. Hose
17. Crush Washer
18. Fitting Bolt

Throttle Control

REMOVING
1. Remove the two machine screws securing the
throttle control to the handlebar.
2. Slide the grommet out of the lower half of the
throttle control; then remove the cable from the
actuator arm.
Back
9-4
19. Switch Bracket
20. Cap Screw
21. Spring
22. Cap Screw
23. Caliper
24. Housing
25. Piston/Seal Set Assy
26. Seal Set
27. Valve
28. O-Ring
29. Bracket Assy
30. Brake Pad
AL610D
Back to TOC
3. Remove the cap screw, lock washer, and washer
securing the actuator arm to the throttle control
lever.
4. Remove the actuator arm and account for a
bushing. Note the position of the return spring
for installing purposes.
Back to Section TOC
0740-359
AF676D
AF677D
Next