Measuring/Adjusting Toe-In/Toe-Out - Arctic Cat ATV 300 Utility/DVX 300 2011 Service Manual

For Arctic Cat Parts Call 606-678-9623 or 606-561-4983
5. Install the handlebar and tighten the clamp cap
screws to 18 ft-lb making sure to tighten the front
cap screws first.
6. Install the instrument pod (Utility) or steering post
cover (DVX).
7. Install the center panel and front rack (Utility).
Measuring/Adjusting
Toe-In/Toe-Out
1. With the ATV on a level surface, center the handle-
bar for straight ahead using a suitable means of mea-
suring centering; then adjust tire pressure to
specifications (see General Information).
2. Support the front of the ATV with the wheels free to
rotate; then center and secure the handlebar.
108
3. Measure the distance (A) and (B) between the front
wheels; then subtract distance (B) from (A). Distance
A - Distance B = Toe-In.
KM590
4. Adjust toe-in to 15 mm (0.60 in.); then measure dis-
tances (C) and (D). Distances (C) and (D) should be
equal.
5. After all the adjustments are to specifications,
tighten the tie-rod lock nuts to 15 ft-lb.
 NOTE: Prior to locking the jam nuts, make sure the
ball joints are at the center of their normal range of
motion and at the correct angle.
 NOTE: The front wheels do not have to be removed
to adjust the tie rod. Also, care should be taken not to
disturb the handlebar position.
KM587
REMOVING (DVX)
1. Remove the seat; then remove the battery hold-down
strap, battery, and starter relay. Lay the relay aside
without disconnecting the wiring.
 NOTE: Always remove the negative battery cable
first; then the positive cable.
KM597
2. Remove the CDI, start-in-gear relay, and fuse block
and lay aside without disconnecting the wires; then
remove the shift knob.
3. Remove the six cap screws securing the body to the
top of the frame; then remove the cap screws from
the bottom of the battery box.
www.mymowerparts.com
Manual
Table of Contents
ATV2205
Body
SP107