Arctic Cat 400 Service Manual page 154

3. Install the pilot bushing with the machined end
directed down; then fit the bushing into the pul-
ley hub.
4. Using a suitable marking pen, make alignment
marks on the fixed face spring holder and both
pulley faces.
5. Place the holding handle on the spring holder
fitting the two dowel pins into the spring holder
face; then install a flat washer and the wing nut.
Turn the wing nut down until resistance is felt.
NOTE: Do not use the wing nut to compress the
spring further.
Back
3-110
CD048
CD067
CD049
Back to TOC
! WARNING
The spring assembly is under pressure. Extreme
care must be taken when relaxing the spring.
Always wear safety glasses. Use proper tools only.
6. Using a spanner and suitable breaker bar, loosen
the notched-ring nut; then spin the nut free of
the hub.
7. Firmly hold the handle and slowly turn the wing
nut counterclockwise to relax the spring.
NOTE: There will be a tendency for the handle to
rotate clockwise approximately ¼ turn as the
spring holder clears the flats or hub. This is due to
a slight counterclockwise preload on the spring.
Back to Section TOC
CD050
CD051
CD052
Next