Assembling Crankcase Half - Arctic Cat 400 Service Manual

3. Install the 3rd drive gear; then install the 5th
drive circlip onto the countershaft.
4. Install the 5th drive washer and 5th drive gear
onto the countershaft.
5. Install the 2nd drive gear and washer onto the
countershaft.
Back
CC199D
CC200D
CC201D
Back to TOC
NOTE: The countershaft is now completely
assembled for installation.
Assembling Crankcase
Half
NOTE: For ease of assembly, install components
on the left-side crankcase half.
NOTE: If the output shaft and gear were
removed, make sure that the proper shim is
installed.
1. To install the output shaft and gear, place the
shaft into position with proper shims, slide the
gear onto the shaft, and secure with a new nut
tightened to specifications.
Back to Section TOC
CD242
3
CC117D
Next
3-241