Arctic Cat 400 Service Manual page 237

8. Remove the
fuel-pump-to-carburetor hose.
9. Remove the cap screws securing the left-side
foot peg and footwell to the footrest; then
remove the footwell.
10. Remove the springs securing the muffler to the
exhaust pipe; then remove the muffler. Account
for two exhaust springs.
11. Remove the cap screws securing the exhaust
pipe to the head; then remove the exhaust pipe.
Back
vacuum hose and
CD766A
CD782
CF138A
Back to TOC
the
12. Remove the E-clip securing the shift rod to the
engine shift arm; then allow the shift rod to
swing forward and hang straight down from the
shift lever.
13. Disconnect the speed sensor connector from the
sensor housing.
14. Remove the four cap screws securing the rear
output joint to the transmission and push the
shaft away from the transmission.
15. Loosen the clamp securing the air intake duct to
the air filter housing.
16. Disconnect the crankcase vent hose from the air
filter housing. Loosen the clamp securing the
carburetor intake duct to the air filter housing;
then remove the housing.
Back to Section TOC
CD803
3
CD805
CD785
Next
3-193