Arctic Cat 400 Service Manual page 165

4. Place the pin into position on the oil pump shaft,
install the oil pump driven gear making sure the
recessed side of the gear is directed inward, and
secure with a new snap ring.
NOTE: Always use a new snap ring when install-
ing the oil pump driven gear.
5. Install the cam chain.
NOTE: Keep tension on the cam chain to avoid
damaging the crankcase boss.
6. Place the pin into position, install the oil pump
drive gear, and tighten the cap screw (coated
with red Loctite #271) securely.
Back
MD1060
MD1020
MD1019
Back to TOC
7. Install the clutch shoe assembly on the crank-
shaft; then install the flange nut (left-hand
thread). Tighten to specifications.
NOTE: The flat side of the flange nut should be
directed towards the clutch shoe.
! CAUTION
Care must be taken when installing the flange nut;
it has "left-hand" threads.
8. Install the one-way sprag clutch making sure
that the green dot or the stamp tag OUTSIDE is
directed away from the crankcase.
9. Install gear position indicator switch contact
pins and springs into the end of the shift shaft.
Back to Section TOC
MD1017
3
MD1018
MD1286
Next
3-121