Arctic Cat 400 Service Manual page 107

7. Install the gear shift shaft.
C. Primary Driven Gear
D. Primary Clutch
E. Starter Clutch Shoe
NOTE: Steps 1-7 in the preceding sub-section
must precede this procedure.
8. Install the spacer, pin, and oil pump drive gear
onto the crank balancer shaft making sure the
shoulder of the drive gear is facing inward
toward the crankcase; then secure with the
washer and nut (threads coated with red Loctite
#271) tightened to specifications.
Back
CC974
CC973
MD1017
Back to TOC
9. Place the chain into the crankcase; then secure it
from the top side with a wire for ease of install-
ing.
10. Install the primary driven washers and shims
onto the driveshaft and crankshaft.
! CAUTION
The clutch sleeve hub and the clutch pressure plate
must be seated in the proper position. If any of the
incorrect positions are used, the hub and plate will
have clearance between them and they will not
operate properly.
11. Simultaneously, place the primary clutch assem-
bly and the starter clutch housing on their
respective shafts making sure the sleeve is prop-
erly positioned in the primary assembly.
Back to Section TOC
CD447
3
CC079D
CC970
Next
3-63