Arctic Cat 400 Service Manual page 125

18. Remove the four cap screws securing the rear
output shaft to the transmission; then push the
shaft to the rear as far as possible.
NOTE: It is advisable to lock the brake when
loosening the cap screws securing the rear drive-
shaft.
19. Remove the positive cable from the starter
motor and route it out of the way.
20. On the TBX model, remove the speedometer
cable from the speedometer gear housing. On
FIS models, disconnect the speed sensor lead
from the wiring harness.
21. Disconnect the stator-to-rectifier/regulator con-
nector.
22. Remove the temperature sensor wires from the
engine.
NOTE: There are two temperature sensors.
Back
CD085
CF172A
Back to TOC
23. Remove the two cap screws securing the front
upper engine mount to the frame.
24. Remove the cap screw and flange nut securing
the upper engine bracket to the engine; then
remove the bracket.
25. Remove the spark plug wire from the spark
plug.
26. Remove the shift indicator connector from the
main wiring harness.
27. Remove the cap screw securing the engine
ground wire to the engine.
28. Remove the two engine mounting through-bolts.
Account for a spacer on the lower front bolt.
Back to Section TOC
CC939
3
CF177
CF193
Next
3-81