Center Crankcase Components; Separating Crankcase Halves - Arctic Cat 400 Service Manual

20. Remove the four cap screws securing the oil
strainer cover; then remove the Phillips-head
screws securing the oil strainer. Account for the
O-ring.
NOTE: Note the directional arrow for installing
purposes.
AT THIS POINT
To service center crankcase components only,
proceed to Separating Crankcase Halves.
Back
MD1060
MD1207
Back to TOC
Center Crankcase
Components
NOTE: This procedure cannot be done with the
engine/transmission
Removing procedures for Top-Side, Left-Side, and
Right-Side must precede this procedure.
NOTE: For efficiency, it is preferable to remove
and disassemble only those components which
need to be addressed and to service only those
components. The technician should use discretion
and sound judgment.
Separating Crankcase
Halves
1. Remove the left-side and right-side cap screws
securing the crankcase halves noting the posi-
tion of the different-sized cap screws for joining
purposes.
2. Using Crankcase Separator/Crankshaft Remover
(p/n 0444-009) and tapping lightly with a rubber
mallet, separate the crankcase halves. Account
for two alignment pins.
Back to Section TOC
in the frame. Complete
MD1006
MD1012
3-93
3
Next