Arctic Cat 400 Service Manual page 487

NOTE: It may be necessary to rotate the body
panel to the right to align the opening with the han-
dlebar.
CLEANING AND INSPECTING
NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is
necessary.
1. Clean all fender components with part-cleaning
solvent and soap and water.
2. Inspect fenders for cracks and/or loose rivets.
3. Inspect for any missing decals.
INSTALLING
1. Rotate the handlebar to the full-left position;
then place the front body panel over the handle-
bar and rotate and lower into position.
2. Connect the headlight connectors to the appro-
priate headlights and the front accessory plug
wires to the accessory plug.
Back
8-18
CD765A
CD765
Back to TOC
3. Make sure the four rubber grommets and bush-
ings are in place; then place the front rack into
position and secure with four machine screws
and flange nuts. Tighten securely.
4. Install one machine screw and flange nut and
four plastic rivets on each side to secure the
front fenders to the footwells. Tighten the flange
nuts securely.
NOTE: If the footwells have been removed, see
Footrests in this section.
5. Install four cap screws securing the front body
panel to the frame and rear panel.
6. Install the shift lever spring, shift lever, and
pivot axle; then tighten the axle nut securely.
Back to Section TOC
CD681
CD679A
CD684A
Next