Installing Left-Side Components - Arctic Cat 400 Service Manual

NOTE: Care should be taken that the alignment
pins are installed in the right-side cover.
20. Place the gasket and right-side cover into posi-
tion making sure the release roller guide remains
correctly positioned and that the water pump
drive adapter aligns; then install the fifteen cap
screws. Note the proper location of the long cap
screw with rubber washer.
21. Tighten the cap screws in a crisscross pattern to
specifications.
22. Place the water pump cover onto the right-side
cover making sure the new O-ring is properly
positioned. Tighten securely with the three cap
screws.
Back
CF067
CF039A
CD910A
Back to TOC
23. Using the oil filter wrench, install a new oil fil-
ter.
24. Install the coolant hose on the water pump and
secure with the clamp.
Installing Left-Side
Components
A. Idle Gear Assembly
B. Magneto Rotor
1. Place the starter into position on the crankcase
and secure with the cap screws. Note the posi-
tion of the wiring form.
Back to Section TOC
CC027D
3
CC067D
CC065D
Next
3-249