Arctic Cat 400 Service Manual page 57

17. Detach the carburetor from the intake boot; then
secure the carburetor assembly away from the
engine.
NOTE: Use cable ties or tape to secure the car-
buretor assembly above the handlebar to keep it
from interfering with the removal procedure.
18. Remove the clamps securing the two oil cooler
hoses to the engine; then disconnect the hoses.
NOTE: After disconnecting the oil cooler hoses,
plug them to prevent leakage from the cooler.
19. Disconnect the high tension lead from the spark
plug. At the ignition coil, remove the cap screw,
nut, and the two wire leads; then remove the coil.
Back
CC119D
CC120D
CC937
Back to TOC
20. Disconnect the battery ground (negative) cable
from the crankcase cover; then disconnect the
positive cable from the starter motor.
21. Disconnect the following electrical components:
voltage regulator, CDI, indicator lights, and the
two wire leads for the oil temperature sensors.
Back to Section TOC
AR600D
3
AR604D
CF165
Next
3-13