Installing Right-Side Components - Arctic Cat 400 Service Manual

7. In a crisscross/case-to-case pattern, tighten the 8
mm cap screws (from steps 3-4) until the halves
are correctly joined; then tighten to specifica-
tions.
NOTE: Rotate the shafts back and forth to
ensure no binding or sticking occurs.
8. In a crisscross/case-to-case pattern, tighten the 6
mm cap screws (from steps 5-6) to specifica-
tions.
NOTE: Rotate the shafts back and forth to
ensure no binding or sticking occurs.
! CAUTION
After completing center crankcase components,
proceed to Installing Right-Side Components, to
Installing Left-Side Components, and to In- stalling
Top-Side Components.
Installing Right-Side
Components
A. Oil Strainer/Oil Pump
B. Gear Shift Shaft
1. Place the oil strainer into position beneath the
crankcase and tighten securely with the Phil-
lips-head cap screws.
Back
CC095D
Back to TOC
2. Place the strainer cap into position on the
strainer making sure a new O-ring is properly
installed and secure with the cap screws; then
install and tighten the oil drain plug to specifica-
tions.
3. Place the oil pump into position in the crankcase
and secure with the three Phillips-head screws
coated with blue Loctite #243. Tighten to speci-
fications.
4. Place the pin and washer into position on the oil
pump shaft, install the oil pump driven gear, and
secure with the circlip.
Back to Section TOC
CC163D
3
CC091D
CC090D
Next
3-245