Left-Side Components; Removing Left-Side Components - Arctic Cat 400 Service Manual

B. Remove each ring by working it toward the
dome of the piston while rotating it out of the
groove.
AT THIS POINT
To service piston, see Servicing Top-Side
Components sub-section.
AT THIS POINT
To service center crankcase components only,
proceed to Removing Left-Side Components.

Left-Side Components

NOTE: For efficiency, it is preferable to remove
and disassemble only those components which
need to be addressed and to service only those
components. The technician should use discretion
and sound judgment.
AT THIS POINT
To service any one specific component, only
limited disassembly of components may be
necessary. Note the AT THIS POINT information
in each sub-section.
NOTE: The engine/transmission does not have
to be removed from the frame for this procedure.
Removing Left-Side
Components
A. Recoil Starter
B. Water Pump
C. Cover
D. Rotor/Flywheel
1. Remove the four cap screws securing the recoil
starter assembly to the left-side cover; then
remove the recoil starter. Account for the gasket.
AT THIS POINT
To service the recoil starter, see Servicing
Left-Side Components sub-section.
2. Remove the flange nut securing the starter cup
to the crankshaft; then remove the starter cup.
Account for the O-ring inside the cup.
Back
Back to TOC
3. Using a cold chisel, scribe a mark showing the
relative position of the shift arm to the shift arm
shaft to aid in installing; then remove the shift
arm.
4. Remove the two cap screws securing the speed
sensor housing; then remove the housing.
Account for the gasket and two seal washers.
5. Loosen the clamps securing the coolant hose to
the water pump; then remove the crossover tube
from the cylinder head. Account for an O-ring.
Back to Section TOC
CD925A
3
CC621
CD920A
Next
3-143