Arctic Cat 400 Service Manual page 350

8. Press the drive bevel gear in until it bottoms; then
apply blue Loctite #242 to the threads (A) of the
bevel gear retainer nut and with the raised side (B)
directed away from the bearing, tighten to
specifications.
9. Press the outer ball bearing in until it is bottomed
out.
10. Using the bearing driver (A), drive the bearing
into the output drive bearing housing until it
bottoms out.
Back
3-306
KX323
KX324
KX325A
Back to TOC
11. Place the output drive bearing housing (A) into the
holding fixture (B); then apply blue Loctite #242
to the threads of the bearing retainer (C). Install
the bearing retainer and tighten to specifications.
12. Secure the output shaft holding fixture (B) and
spacer (C) in a vise; then hold the housing
assembly (A) and install the output shaft (D) in
the housing.
13. Apply blue Loctite #242 to the threads of the
output shaft retainer nut (E) and with the pro-
truding side (F) directed away from the bearing,
tighten to specifications.
14. Apply grease to the output drive oil seal; then
install in the housing being careful not to dam-
age the lip of the seal or distort the seal.
Back to Section TOC
KX326
KX327
KX328
Next