Arctic Cat 400 Service Manual page 438

2. Install the input shaft seal making sure it is flush
with the edge of the housing.
3. Lubricate the input shaft splines with High-Per-
formance Grease (p/n 0436-501).
NOTE: Any time drive splines are separated,
clean all splines with parts-cleaning solvent and
dry with compressed air; then lubricate with rec-
ommended grease.
Back
AF993
AF994
KX221
Back to TOC
4. On the 400 FIS/500/650 H1, install the input
shaft into the housing; then install the front boot
and secure with Boot Clamp (p/n 0423-393) and
the rear boot with Boot Clamp (p/n 0423-411).
5. On the 400 FIS/500/650 H1, place the pinion
housing with new gasket onto the gear case
housing; then secure with the existing cap
screws. Tighten to specifications.
NOTE: If a new gear case housing is being
installed, tighten the cap screws to 3.5-4.3 kg-m
(25-31 ft-lb).
Back to Section TOC
KX222
CD112
6
CD099
Next
6-9