Installing Right-Side Components - Arctic Cat 400 Service Manual

AT THIS POINT
After completing center crankcase components,
proceed to Installing Right-Side Components, to
Installing Left-Side Components, and to In-
stalling Top-Side Components.
Installing Right-Side
Components
1. Install the shift indicator sending unit making
sure the two neutral contact pins and the two
springs are properly positioned. Tighten the
Allen-head screws securely.
2. Install the secondary shaft bearing housing mak-
ing sure the two alignment pins are properly
positioned. Tighten the Allen-head screws
securely.
Back
CC661A
CC602
Back to TOC
3. Install the oil pump onto the engine; then tighten
the Phillips-head screws securely.
4. Install the oil pump drive gear spacer onto the
crank balancer shaft. Grease the pin and insert it
into the shaft; then install the drive gear making
sure the raised side of the gear is facing toward
the inside. Secure the gear with the cap screw
(threads coated with red Loctite #271) and the
washer. Tighten the cap screw to specifications.
5. Grease the driven gear pin and insert it into the
oil pump shaft; then install the driven gear (not-
ing the direction of the sides of the gear from
removing). Secure with a snap ring.
Back to Section TOC
CC711
3
CC613
CC712
Next
3-177