Arctic Cat 400 Service Manual page 290

5. Place the gear shift cam plate and guide onto the
gear shift cam making sure the alignment pin
was installed. Secure assembly with the cap
screw coated with blue Loctite #243. Tighten
securely.
6. Attach the spring to the gear shift cam stopper
arm.
Back
3-246
CC088D
CF073A
CC164D
Back to TOC
7. Install the gear shift shaft.
C. Primary Driven Gear
D. Primary Driven Clutch
E. Primary Drive Clutch Shoe
NOTE: Steps 1-7 in the preceding sub-section
must precede this procedure.
8. Install the spacer, pin, and oil pump drive gear
onto the crank balancer shaft making sure the
shoulder of the drive gear is facing inward
toward the crankcase; then secure with the
washer and nut tightened to specifications.
Back to Section TOC
CC086D
CF072A
CC085D
Next