Speedometer/Tachometer/Lcd (400 Fis/500/ 500 Tbx/Trv/650 H1/650 V-Twin) - Arctic Cat 400 Service Manual

4. Using two open-end wrenches, remove the lock
nut securing the shift rod to the upper shift arm.
Remove the shift rod and discard the lock nut.
NOTE: Never reuse a lock nut. Once a lock nut
has been removed, it must be replaced with a new
lock nut.
INSTALLING
1. Place the shift rod into position on the engine
shift arm and secure with the existing E-clip
(TBX/TRV/400/500/650 H1). On the 650
V-Twin, connect the front and rear shift arms
with two cap screws. Only finger-tighten at this
time.
2. Using a new lock nut (B), secure the shift rod to
the upper shift arm; then using two open-end
wrenches, tighten securely.
Back
9-8
CD717
AF941A
Back to TOC
3. Place the spring into position between the upper
shift arm and shift lever; then making sure the
O-rings are in place on the axle, secure the shift
lever to the arm with the existing axle and nut.
4. Check shift lever adjustment (see Section 2);
then tighten jam nut (A) securely.
5. Install the left-side splash panel.
Speedometer/
Tachometer/LCD
(400 FIS/500/500 TBX/TRV/
650 H1/650 V-Twin)
REPLACING SPEEDOMETER
To replace the speedometer, use the following pro-
cedure.
1. Remove the two reinstallable rivets securing the
instrument pod; then remove the ignition switch
retaining ring.
2. Remove the two nuts securing the mounting
studs; then remove the speedometer and discon-
nect the multi-pin connector.
3. Mount the speedometer and secure with the two
nuts; then connect the multi-pin connector.
4. Install the instrument pod and secure with the
reinstallable rivets.
5. Secure the ignition switch with the retaining
ring.
Back to Section TOC