Arctic Cat 400 Service Manual page 437

4. Remove the input shaft from the pinion housing.
5. Using a seal removal tool, remove the input
shaft seal. Account for a spacer.
6. Remove the snap ring securing the input shaft
bearing; then place the pinion housing in a press
and remove the bearing.
Back
6-8
CD114
CD107
AF982
Back to TOC
Assembling Input Shaft
1. Place the pinion housing in a press and install
the input shaft bearing. Secure the bearing with
the existing snap ring making sure the sharp
edge of the snap ring faces to the outside.
Back to Section TOC
AF983
AF984
KX219
Next