Arctic Cat 400 Service Manual page 218

NOTE: If heating the bearing is not possible, the
crankshaft can be installed using a crankshaft
installing tool.
4. Install the crank balancer.
Back
3-174
CC688
CC689
CC690
CD832B
Back to TOC
NOTE: It will be necessary to rotate the crank
balancer until the counterweight is facing away
from the crankshaft; then rotate the crankshaft
clockwise into the journal area to allow the crank
balancer to be fully seated.
5. Place the key into the crank balancer keyway;
then install the crank balancer gear making sure
the alignment dots on the crank balancer gear
and the crankshaft gear align.
6. Place a washer on each end of the countershaft
assembly; then install the assembly.
7. Install the driveshaft.
8. Place a washer on each end of the gear shift shaft;
then install the shaft assembly making sure the two
holes on the end of the shaft are positioned
vertically.
Back to Section TOC
CD826A
CC674
CC675
Next