Arctic Cat 400 Service Manual page 420

4. Install the armature into the starter housing; then
while holding the brushes out, slide the commu-
tator into the brush holder.
5. Apply a small amount of grease to the rear cover
bushing; then install the cover on the starter
housing making sure the reference marks align.
6. In order, install the thick metal washer, thin
metal washer, and the fiber washer on the arma-
ture shaft; then install the housing O-ring on the
starter housing.
Back
BC010
BC006
BC013
Back to TOC
7. Apply a small amount of grease to the front
cover bearing and seal; then install the seal pro-
tector.
8. Place the front cover onto the starter housing
making sure it seats properly.
9. Apply red Loctite #271 to the threads of the two
long cap screws and install. Tighten to 0.8-1.2
kg-m (6-9 ft-lb).
Back to Section TOC
BC014
5
BC015
BC004
Next
5-21