Arctic Cat 400 Service Manual page 486

7. Remove the torx-head cap screws and nylon ties
securing the left-side and right-side splash pan-
els; then remove the panels.
8. Remove one shoulder screw and four plastic riv-
ets on each side to separate the front panel lower
fenders from the left-side and right-side foot-
wells.
9. Remove the shift knob retaining pin and remove
the shift knob; then remove the shift lever pivot
axle nut and remove the axle and shift lever.
Account for a spring and two O-rings.
Back
CD685
CD691
CD682
Back to TOC
10. Disconnect four headlight connectors and secure
the wires out of the way; then disconnect the
wires to the front accessory plug.
11. Rotate the handlebar to the full-left position;
then lift and slide the panel to the rear and lift
the rear up to clear the handlebar.
Back to Section TOC
CD779
CD780A
8
CD681
Next
8-17