Arctic Cat 400 Service Manual page 195

5. Remove the countershaft assembly (D). Account
for a washer on each end of the countershaft.
NOTE: Do not disassemble the countershaft
assembly unless necessary. If necessary, see Ser-
vicing Center Crankcase Components sub-sec-
tion.
6. Using a rubber mallet, tap on the crankcase to
remove the driveshaft.
7. Note the alignment dots on the crank balancer
assembly (B) gear and crankshaft (C) gear for
assembling purposes; then slide the crank bal-
ancer gear off the crank balancer. Account for
the key in the keyway.
Back
CC672
CC674
CC675
Back to TOC
8. Remove the crank balancer.
NOTE: There is a flat spot on the crank balancer
bearing flange to allow clearance past the crank-
shaft.
9. Remove the snap ring securing the water pump
driven gear shaft.
10. Using a hydraulic press, remove the crankshaft
assembly.
NOTE: Use a protective end cap to prevent dam-
age to the crankshaft threads.
11. Remove the cap screws securing the oil strainer
cap; then remove the cap. Account for the cap
O-ring.
Back to Section TOC
CD826
3
CD832B
CC680
Next
3-151