Arctic Cat 400 Service Manual page 166

10. Install gear position indicator switch making
sure the O-ring is well-oiled and properly posi-
tioned. Tighten cap screws securely.
B. Clutch Cover
C. Fixed Drive Face
D. Movable Drive Face
NOTE: Steps 1-10 in the preceding sub-section
must precede this procedure.
11. Install two alignment pins and place the clutch
cover gasket into position. Install the clutch
cover.
12. Tighten the clutch cover cap screws to specifica-
tions.
Back
3-122
MD1043
MD1040
MD1115
Back to TOC
13. Install the air intake plate. Apply red Loctite
#271 to the threads of the three Phillips-head
cap screws; then install and tighten securely.
14. Place the driven pulley assembly into position
and secure with the nut (threads coated with red
Loctite #271). Tighten to specifications.
Back to Section TOC
MD1117
MD1342
MD1068
Next