Arctic Cat 400 Service Manual page 182

27. Remove the two engine mounting through-bolts.
Account for a washer and a spacer on the bolts.
28. Raise the rear of the engine enough to allow the
rear output flange to clear the output flange
joint. Block the engine up in this position.
29. Remove the first small boot clamp; then remove
the output flange and driveshaft from the rear
drive coupler.
Back
3-138
CD810
CD809
CD811
Back to TOC
30. Remove the block from under the engine and
lower the engine; then remove the boot clamp
from the front output drive yoke.
31. Move the engine to the rear enough to allow the
front driveshaft to clear the front output yoke;
then move the engine forward and to the left.
The engine will come out the left side of the
frame.
Back to Section TOC
CD812A
CD813
CD818
Next