Arctic Cat 400 Service Manual page 63

4. Remove the gear shift stopper (located above the
hi/low shift shaft). Account for the washer, spring,
and stopper.
NOTE: On the FIS models, remove the two cap
screws securing the speed sensor housing; then
remove the housing. Account for the gasket.
5. Remove the cap screws securing the left-side
cover to the crankcase (fifteen 6 mm and one 8
mm); then using a slide hammer w/6 mm Adapter
(p/n 0644-310), remove the left-side cover.
Back
CC943
CC944
CF109
Back to TOC
NOTE: Inspect the inside of the left-side cover
for any shaft washers and spacers that may have
come off with the cover. Make sure they are
returned to their respective shafts. Also, make
sure the alignment pins are in place.
B. Rotor/Flywheel
C. Idle Gear Assembly
NOTE: Steps 1-5 in the preceding sub-section
must precede this procedure.
NOTE: For steps 6-14, refer to illustration
CC948B.
NOTE: To aid in installing, it is recommended
that the assemblies are kept together and IN
ORDER.
Back to Section TOC
CC945
3
CC946
Next
3-19