Arctic Cat 400 Service Manual page 230

18. Rotate the crankshaft until the second cap screw
securing the sprocket to the camshaft can be
installed; then install the cap screw (threads
coated with red Loctite #271) and tighten to
specifications. Bend the tab to secure the cap
screw.
19. Rotate the crankshaft until the first cap screw
(from step 17) can be addressed; then tighten to
specifications. Bend the tab to secure the cap
screw.
20. Place the C-ring into position in its groove in the
cylinder head.
Back
3-186
CD465
CD466
CC012D
Back to TOC
21. Install the cylinder head plug in the cylinder
head with the open end facing downward and
toward the inside.
! CAUTION
The open end of the plug must be positioned down-
ward.
22. Remove the cap screw from the end of the chain
tensioner; then using a flat-blade screwdriver,
rotate the adjuster screw inside the tensioner
clockwise until the screw bottoms.
NOTE: The adjuster shaft will be drawn into the
tensioner as the adjuster screw is rotated clock-
wise. The adjuster shaft tension will be released in
step 24.
23. Place the chain tensioner adjuster assembly and
gasket into position on the cylinder and secure
with the two Allen-head cap screws.
Back to Section TOC
CD468
CD501
Next