Arctic Cat 400 Service Manual page 247

NOTE: To aid in installing, it is recommended
that the assemblies are kept together and IN
ORDER.
9. Remove the starter gear assembly (F) from the
crankcase; then remove the starter idler gear (G)
and spacer.
10. Remove the idle gear (C), washer, and spacer
from the countershaft.
11. Remove the #2 drive gear (B), washer, and the
select sliding dog gear from the driveshaft.
Account for a bushing and a washer.
AT THIS POINT
To service shift fork, see Servicing Left-Side
Components sub-section.
Back
CD136
CD138
CD141
Back to TOC
12. Remove the shift fork shaft (D) from the crank-
case boss; then remove the shift fork from the
shaft. Remove the shift shaft assembly (E) from
the fixed shaft. Account for the left shaft washer.
13. Remove the circlip and washer from the drive-
shaft; then remove the #1 drive gear (B).
Account for a splined bushing and a spacer.
Back to Section TOC
CD146
3
CD147
CD152
Next
3-203