Arctic Cat 400 Service Manual page 447

NOTE: Prior to installing the seal, apply grease
to the seal outside diameter.
4. Install the seal into the housing pressing evenly
on the outside edge until the seal is seated.
5. Repeat steps 1-4 for the opposite side.
INSTALLING DIFFERENTIAL
1. Align the splined input yoke with the front out-
put splines; then place the differential into posi-
tion on the frame and install the cap screws,
washers, and flex-lock nuts. Tighten to specifi-
cations. Make sure the rubber boot is properly
seated on the input yoke.
Back
6-18
CC901
CD018
CD857
Back to TOC
2. Pour 275 ml (9.3 fl oz) of SAE 80W-90 hypoid
lubricant into the differential and install the
filler plug. Tighten to specifications.
3. Install the front drive actuator with the three
torx-head cap screws; then connect the wire
connector to the main wiring harness.
4. Install the inner fender panels.
5. Install the front axles (see Drive Axles in this
section).
6. Secure the upper A-arms with cap screws and
lock nuts. Tighten to specifications.
7. Secure the lower shock eyelets with cap screws
and lock nuts. Tighten to specifications.
Back to Section TOC
CD859
AG925
AF610D
Next