Arctic Cat 400 Service Manual page 357

Installing Left-Side
Components
1. Install a new circlip (A) securing the oil pump
rotor (B) in rotor (C); then apply clean engine oil
to the rotors and shaft (D).
2. Make sure that alignment pins (A) are in place and
apply clean engine oil to oil port (B).
3. Install the oil pump drive chain (A) with the oil
pump assembly (B); then tighten the cap screws
(C) to specifications.
Back
KX350A
KX351
KX352
Back to TOC
4. Install the upper chain guide (A) with the tab (B)
directed downward; then install the lower chain
guide (C) and collar (D). Tighten the chain guide
attaching bolts to specifications.
5. Apply grease to the O-ring (A); then install the pin
(B), spring (C), and oil pump chain tensioner bolt
(D) and tighten to specifications.
6. Install new O-rings (A) on the oil pipe fittings;
then apply clean engine oil and install on the
crankcase tightening the oil pipe cap screws to
specifications.
7. Install the pick-up coil (A) and stator (C) and
tighten cap screws (B) to specifications; then
install the lead grommets (D) in the alternator
cover.
Back to Section TOC
ATV2094
3
ATV2095
KX353
Next
3-313