Arctic Cat 400 Service Manual page 482

4. Remove the left-side and right-side fender
splash panels; then remove one press-in fastener
and one reinstallable rivet from the left side and
right side of the air-intake splash shroud. Do not
remove the shroud.
5. Disconnect the four headlight connectors and
the taillight/brakelight connector from the sock-
ets.
6. Remove the shift knob; then remove the nut and
axle pivot bolt securing the lever to the shift
lever axle. Remove the shift lever. Account for
the two O-rings on the axle bolt and one spring.
7. Remove the front and rear racks; then remove
the two body bolts adjacent to the air filter hous-
ing and two push nuts located behind the grille.
Back
CF135A
CD779
CD780A
Back to TOC
8. Remove the two cap screws and lock nuts secur-
ing the left foot peg and remove the foot peg.
9. Remove eight cap screws and lock nuts and one
reinstallable rivet securing the right-side foot-
well to the fenders.
10. Lift and support the rear of the body to allow
access to the torx-head cap screws securing the
front and rear body sections together; then
remove six self-locking nuts (three from each
side). Remove the rear body panel; then remove
the front one.
Back to Section TOC
CF201A
CF160A
8
CD782
Next
8-13