Top-Side Components - Arctic Cat 400 Service Manual

22. Loosen the clamp on the crankcase breather vent
hose; then disconnect the hose and remove it.
23. Remove the
fasteners in the following sequence:
A. Upper front: Two cap screws (inside the
bracket) and one cap screw and nut (topside of
the engine).
NOTE: It will be necessary to remove the upper
front bracket to remove the engine.
B. Lower front: One cap screw, nut, spacer, and
washer.
C. Lower rear: One cap screw and nut with flat
washer.
Back
3-14
engine/transmission mounting
Back to TOC
CF164A
24. By sliding the rear of the engine out first, remove
the engine/transmission from the left side of the
frame.

Top-Side Components

NOTE: For efficiency, it is preferable to remove
and disassemble only those components which
CF177
need to be addressed and to service only those
components. The technician should use discretion
and sound judgment.
To service any one specific component, only
limited disassembly of components may be
necessary. Note the AT THIS POINT information
in each sub-section.
NOTE: The engine/transmission does not have
to removed from the frame for this procedure.
CF175
Back to Section TOC
AT THIS POINT
CF176
CC940
Next